User Tools

Site Tools


proton:raspi_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
proton:raspi_setup [2016/06/19 12:40]
seth
proton:raspi_setup [2016/06/23 07:29]
seth
Line 37: Line 37:
 sudo make install ​ sudo make install ​
 </​code>​ </​code>​
- 
-  * To test, type "​glxgears"​ from a shell inside of the GUI desktop 
  
  
Line 51: Line 49:
  
 The last step of the build copies the rtbarebones binary to /​RTBareBones/​bin (as that's where the media is), so go to that dir and run "​./​rtbarebones"​ and it should work. The last step of the build copies the rtbarebones binary to /​RTBareBones/​bin (as that's where the media is), so go to that dir and run "​./​rtbarebones"​ and it should work.
 +
 +RTSimpleApp is much the same, although you'll need SDL2's mixer as well.  Unlike with the base SDL2, we can just grab a pre-compiled one like this:
 +<​code>​
 +sudo apt-get libsdl2-mixer-dev
 +</​code>​
 +And that should compile ok. It should run 60+ fps at 720p on a Raspi 3.
  
proton/raspi_setup.txt ยท Last modified: 2016/06/23 07:29 by seth