User Tools

Site Tools


This is an old revision of the document!

Experimental and for linux pros only

Here is how to setup the Raspberry Pi to support normal OpenGL (with acceleration) and be able to compile the Proton SDK examples. It's actually also possible to set things up for GLES, but this is probably easier these days. (tested with Raspbian “Jessie” on 6/18/2016)

These steps are what I use to compile stuff by copying things from my Windows computer. A normal user would probably just grab the svn tree and run .sh files.

  • Give the video card more memory on the pi. Run raspi-config and give it 128 or 256 (good for the pi3)
  • Also enable the experimental OpenGL driver under the Advanced section in raspi-config
  • Install cmake on the pi (sudo apt-get install cmake)
  • Do “sudo rpi-update” to make sure your firmware is updated
  • Run the following from a shell:
sudo apt-get -y install xcompmgr libgl1-mesa-dri && sudo apt-get -y install libalut0 libalut-dev && sudo apt-get -y install mesa-utils

sudo apt-get install libglu1-mesa-dev freeglut3-dev mesa-common-dev
  • Do the following from a shell window to install SDL2 from source:
cd ~ 
tar zxvf SDL2-2.0.4.tar.gz 
cd SDL2-2.0.4 && mkdir build && cd build 
../configure --disable-pulseaudio --disable-esd --disable-video-mir --disable-video-wayland
make -j 5 
sudo make install 
  • To test, type “glxgears” from a shell inside of the GUI desktop

Step 2: Proton stuff

  • Install linux tools for Windows, rsync and ssh should work from the command line
  • Setup a ssh key pair so you don't have to type passwords
  • Edit SetupVars.bat and edit the IP to the pi
  • Run CopyStuffToPi.bat. There should now be a ~/proton tree on the pi
  • Edit the RTBareBones/linux/CMakeLists.txt file and make sure “OPTION(RASPBERRYPI_OPENGL “Compile for Raspi 3 OpenGL” ON)” is uncommented
  • RTBareBones/CopyStuffToPiAndCompileLoop.bat and it should update that example and compile it in a loop

You'll have to the copy the RTBareBones/bin/interface dir to /RTBareBones/linux as that has font/graphics needed.

Running “./rtbarebones” from the RTBareBones/linux dir should now work.

That should be enough to get you going.

proton/raspi_setup.1466256057.txt.gz · Last modified: 2016/06/18 13:20 by seth