User Tools

Site Tools



This shows you the differences between two versions of the page.

Link to this comparison view

proton:raspi_opengl_setup [2016/06/19 12:36] (current)
seth created
Line 1: Line 1:
 +** Setting up Raspbery Pi to compile Proton SDK examples in X11 via SDL2 and the OpenGL experimental driver **
 +These steps are what I use to compile stuff by copying things from my Windows computer. ​ A normal user would probably just grab the svn tree and run .sh files.
 +  * Give the video card more memory on the pi.  Run raspi-config and give it 128 or 256 (good for the pi3)
 +  * Also enable the experimental OpenGL driver under the Advanced section in raspi-config
 +  * Install cmake on the pi (sudo apt-get install cmake)
 +  * Do "sudo rpi-update"​ to make sure your firmware is updated
 +  * Run the following from a shell:
 +sudo apt-get -y install xcompmgr libgl1-mesa-dri && sudo apt-get -y install libalut0 libalut-dev && sudo apt-get -y install mesa-utils
 +sudo apt-get install libglu1-mesa-dev freeglut3-dev mesa-common-dev
 +  * Do the following from a shell window to install SDL2 from source:
 +cd ~ 
 +wget https://​​release/​SDL2-2.0.4.tar.gz ​
 +tar zxvf SDL2-2.0.4.tar.gz ​
 +cd SDL2-2.0.4 && mkdir build && cd build 
 +../​configure --disable-pulseaudio --disable-esd --disable-video-mir --disable-video-wayland
 +make -j 5 
 +sudo make install ​
 +  * To test, type "​glxgears"​ from a shell inside of the GUI desktop
 +Step 2: Proton stuff
 +  * Install linux tools for Windows, rsync and ssh should work from the command line
 +  * Setup a ssh key pair so you don't have to type passwords
 +  * Edit SetupVars.bat and edit the IP to the pi
 +  * Run CopyStuffToPi.bat. ​ There should now be a ~/proton tree on the pi
 +  * Edit the RTBareBones/​linux/​CMakeLists.txt file and make sure "​OPTION(RASPBERRYPI_OPENGL "​Compile for Raspi 3 OpenGL"​ ON)" is uncommented ​
 +  * RTBareBones/​CopyStuffToPiAndCompileLoop.bat and it should update that example and compile it in a loop
 +The last step of the build copies the rtbarebones binary to /​RTBareBones/​bin (as that's where the media is), so go to that dir and run "​./​rtbarebones"​ and it should work.
proton/raspi_opengl_setup.txt ยท Last modified: 2016/06/19 12:36 by seth